The Sentinel�
Remote Lamp Indicator
monitors lamp operation
of one, two, or four
lamp ultraviolet
fixtures and is equipped
with a 25-foot connector
cord. Additional 25-foot
extensions are
available.
The Sentinel�
Remote Lamp Indicator
can be configured for
use with a wide variety
of germicidal
ultraviolet fixtures and
will operate either 120
Volt 50/60 Hertz or
220-240 Volt 50/60 Hertz
fixtures using either
magnetic or electronic
ballasts. The Sentinel�
Remote Lamp Indicator
mounts on a surface
within 25� of an
ultraviolet unit. The
wires and sensors of the Sentinel� are
connected to the
fixtures through holes
in the wall of the
fixture. The sensors
detect the flow of
current from the lamps,
activating the
indicators on the face
of the Sentinel�.
When a sensor does not
detect a current, its
corresponding indicator
will not light. For use
with various lines of
air disinfection
equipment.
Sentinel Sell Sheet
Sentinel Manual
Complete
Part Number
Description
350250A1
For use with
fixture
utilizing SINGLE
lamp &
electronic
ballast
350250A2
For use with
fixture
utilizing TWO
lamps &
electronic
ballast(s)
350250A3
For use with
fixture
utilizing FOUR
lamps &
electronic
ballast(s)
350250A4
For use with
fixture
utilizing SINGLE
lamp & magnetic
ballast
350250A5
For use with
fixture
utilizing TWO
lamps & magnetic
ballast(s)
350250A6
For use with
fixture
utilizing FOUR
lamps & magnetic
ballast(s)
The
Zenith�
ultraviolet meter is
a sensitive, hand-held,
ultraviolet meter; used
to check the intensity
of aging ultraviolet
lamps and survey rooms
utilizing an air
sanitizer to ensure that
the ultraviolet radiant
exposure of personnel
within the treated area
is within acceptable
limits.
The
Zenith�
ultraviolet meter
provides accurate and
easy-to-read-levels of
intensity. A narrow
ultraviolet band pass
filter in combination
with the photodiode
detector makes the
Zenith�
insensitive to ambient
lighting within the area
being surveyed.
Zenith�
monitor is powered by a
single 9-volt DC
alkaline battery and an
internal battery-saver
will automatically shut
off the meter after 30
minutes of inactivity.
SaniRay�
is a
registered trademark of the
Atlantic Ultraviolet
Corp.
Copyright 1995-2021 All rights reserved. The information and recommendations contained in this publication are
based upon data collected and are believed to be correct. However, no guarantee or warranty of any
kind, expressed or implied, is made with respect to the information contained herein. Specifications and information are subject to change without notice.
