You are here > Home Page > SaniLight Germicidal Ultraviolet Irradiators

 
 Home

 PRODUCT By NAME

 PRODUCT by Residential
 Ultraviolet
APPLICATION

Water
Purification
Room Air /Air Duct Sanitizers

 PRODUCT  by Commercial
 Ultraviolet
APPLICATION

Water
Purification
Liquid
Disinfection
Wastewater Disinfection
Room Air/Air Duct Sanitizers
Air & Surface Disinfection
Storage Tank Air Sterilizers
Pond, Lake and Swimming Pool UV, Aeration/Ozonation

UV Germicidal
Lamps, Lamp Holders, Quartz
BL

Black Light Fixtures

Safety Warnings
& Instructions

SaniLight Germicidal Ultraviolet Irradiators
SaniLight Monitoring Options

The Sentinel� Remote Lamp Indicator monitors lamp operation of one, two, or four lamp ultraviolet fixtures and is equipped with a 25-foot connector cord. Additional 25-foot extensions are available.

The Sentinel� Remote Lamp Indicator can be configured for use with a wide variety of germicidal ultraviolet fixtures and will operate either 120 Volt 56/60 Hertz or 220-240 Volt 50/60 Hertz fixtures using either magnetic or electronic ballasts. The Sentinel� Remote Lamp Indicator mounts on a surface within 25� of an ultraviolet unit. The wires and sensors of the Sentinel are connected to the fixtures through holes in the wall of the fixture. The sensors detect the flow of current from the lamps, activating the indicators on the face of the Sentinel. When a sensor does not detect a current, its corresponding indicator will not light. For use with various lines of air disinfection equipment.
Sentinel Sell Sheet  Sentinel Manual

Complete Part Number Description
350250A1 For use with fixture utilizing SINGLE lamp & electronic ballast
350250A2 For use with fixture utilizing TWO lamps & electronic ballast(s)
350250A3 For use with fixture utilizing FOUR lamps & electronic ballast(s)
350250A4 For use with fixture utilizing SINGLE lamp & magnetic ballast
350250A5 For use with fixture utilizing TWO lamps & magnetic ballast(s)
350250A6 For use with fixture utilizing FOUR lamps & magnetic ballast(s)



Zenith� Sell Sheet
Zenith� Owner's Manual

Zenith� Ultraviolet Meter

The Zenith� ultraviolet meter is a sensitive, hand-held, ultraviolet meter; used to check the intensity of aging ultraviolet lamps and survey rooms utilizing an air sanitizer to ensure that the ultraviolet radiant exposure of personnel within the treated area is within acceptable limits.

The Zenith ultraviolet meter provides accurate and easy-to-read-levels of intensity. A narrow ultraviolet band pass filter in combination with the photodiode detector makes the Zenith insensitive to ambient lighting within the area being surveyed. Zenith  monitor is powered by a single 9-volt DC alkaline battery and an internal battery-saver will automatically shut off the meter after 30 minutes of inactivity.

SaniLight is a registered trademark of the Atlantic Ultraviolet Corp.
SaniLight
Product
Overview
Product
Features
Product
Photos
Commercial
Models
Ultraviolet
Dosage
Installation
Maintenance
Monitoring
Options
Optional
Accessories
Replacement Parts
Adobe Acrobat PDF Library for SaniLight
Copyright 1995-2021 All rights reserved. The information and recommendations contained in this publication are based upon data collected and are believed to be correct. However, no guarantee or warranty of any kind, expressed or implied, is made with respect to the information contained herein. Specifications and information are subject to change without notice.
 
 
  Home   |  Product by Name